Buffy the Vampire Slayer's Scythe

[Timbog1]

Hello RPFers!

For months I have been working on this Sythe from Buffy The Vampire Slayer.
It's coming along nicely, however I have reached a point where I am not sure how to proceed.
Below is what I've done so far.



My problem now is making the metal spikes like seen below:


I've tried wood dowels, sadly with not much luck. I should try them again.
I also do not have any metal working tools.
Any ideas?
Thanks!

 

[CynderBloc]

Do you mean the bits at the top of the stake that look like fins?

If it was me, I'd make them out of Apoxie. Probably start with a fairly thick copper wire as an armature

 

[Timbog1]

Hey CynderBloc...yes the bits right above the stake. When you say Apoxie, do you mean Apoxie Sculpt? If so, I think I can do that...but I am not sure that I can get them perfect. But I guess I can strive to do so. Thanks for the help!

 

[CynderBloc]

Hey CynderBloc...yes the bits right above the stake. When you say Apoxie, do you mean Apoxie Sculpt? If so, I think I can do that...but I am not sure that I can get them perfect. But I guess I can strive to do so. Thanks for the help!

Yeah, I meant Apoxie Sculpt. It is sandable don't forget, so you can get it close and once it's cured, sand it to the exact shape

 

[Timbog1]

Thanks for your help CynderBloc. I think that is what I am going to do!

 

[AbelSaunders]

Do you mind me asking where you got the templates for the Scythe? I've been looking for awhile but I can never find much, I ended up here looking for pepakura files for the scythe, that would be amazing right?

 

[Watson]

I could laser cut those for you, I would just need to know size specifics

 

[cyberfez]

Does anyone have the definative measurements of each section of this Scythe. Anyone got a template on the shape of the scythe blade and or fins?

Cyberfez