I can't find the extreme heat spray paint you mentioned. Should I go with flat black or semi gloss black spray paint?
That was just black paint I had at hand from another project. It's not important. I would go with the semi gloss black.
I can't find the extreme heat spray paint you mentioned. Should I go with flat black or semi gloss black spray paint?
Thanks folks, much appreciated. @NeilDavies - I’m not sure if there’s an agreed size for the ammo box or not. I just made it up.
Thanks folks, much appreciated. @NeilDavies - I’m not sure if there’s an agreed size for the ammo box or not. I just made it up.
I agree with @Candykiller mate, this was mine made a few years ago and it was designed to hold the modded .44sp rounds I created for the blaster
I have three different Blade Runner builds on the go at the moment and I will use this thread to post pics of all of them as I make progress. Today’s task was to clean up this piece of junk I picked up from eBay in preparation for recreating this BR 2049 prop.
View attachment 747423View attachment 747424View attachment 747425
And here are a couple of my older scratch-built Blade Runner replicas. I still need to do a bit of ageing on both of these pieces.
View attachment 747426View attachment 747428View attachment 747429
A couple of updated photos of my water blaster now that I have added the LEDs. (non functional)
View attachment 754148View attachment 754149View attachment 754150
A couple of updated photos of my water blaster now that I have added the LEDs. (non functional)
View attachment 754148View attachment 754149View attachment 754150
What's the appropriate size LED? I assume you just drilled out the cast LEDs and inserted these from the outside, rather than like...dismantling and inserting them from the inside?