My pleasure Dan. Sharing keeps me at it!Thanks for this thread - I'm about ready to begin my assembly and this is a great illustrated tutorial!
Looking good!
Dan
Hmm. I’m thinking the flap on the left gets bent up not down?
The rail is .05" so its thinner.What is the thickness of the material, that the scope rail is made of?
The original is quite thin with about 0,064"
My first approach would be to reduce the thickness at the spot, where the scope rings attach.
My second approach would be to reduce the width a bit.
But be assured, that even on my real BC, the scope rings are not dead center on the rail
I did the same thing. But overall I’m not looking to replicate that pictures tilt because I think it may be exaggerated by some of the camera angles and the prod being off the center line.I drew this up in illustrator, the degrees may be slightly off but it shows the tilt on the bowcaster.
Hope this helps
View attachment 1506829