Blocking Tie pilot helmet hoses holes

[Twinsen]

Hey there,

I've just received a TIE pilot helmet I bought from a fellow RPF member, but since it came without the chest armor the hoses are just... Well hanging down.

It doesn't look THAT bad, but you know. I've tried tying them up inside, but it looks awful. They are pretty short so there's no way to roll them up.

Removing them is the best way to solve the problem, but then I have two giant holes on the faceplate.

Does anyone make "caps" to block the holes ?

Or maybe someplace I can buy longer hoses from ?

Any suggestions welcome :thumbsup

Thanks

 

[Clutch]

Just cut some sheet styrene to shape, paint black, and hotglue from the inside. Done.

 

[Twinsen]

Thanks i'll look into that :thumbsup

 

[LDR]

or maybe black material on the side, so you can remove it easy enough if you do get the armour?