chinbeard
Active Member
I was tapped to build a Battlestar Galactica Colonial Pistol for a Halloween costume. I much prefer the season 1 version that was based on the Smith & Wesson Model 686 revolver and I was given leeway to pick the version, so that's the one that I went with. I whipped up a vector for this and printed it out to get the party started.
I made the center layer out of 3/8" foam PVC and each layer outward out of 1/8" foam PVC.
The grenade launcher bit was made separately and attached later.
As the pieces were attached to the main part they were shaped with a Dremel.
With all of the pieces attached and roughly shaped, it's time to start sanding and filling to get this puppy mold ready!
I made the center layer out of 3/8" foam PVC and each layer outward out of 1/8" foam PVC.
The grenade launcher bit was made separately and attached later.
As the pieces were attached to the main part they were shaped with a Dremel.
With all of the pieces attached and roughly shaped, it's time to start sanding and filling to get this puppy mold ready!