I think I know how you feel! For my 1:144 Falcon, I overdid the topside, and kinda half-assed the underside. I didn't ignore the underside completely however. I still added a decent amount of weathering and detail there. I might likely do the same for this 1:72 model right now.I found doing the underside more tedious for some reason. Spent lots of time doing the top, but just kind of did a quick pass underneath. It is sometimes hard to maintain focus
Any progress on the two missing parts? I need to know where they go, because I'm getting close to finishing the model.Great work.
I think the natural light shot looks better tone wise
You did a nice job disguising the bare plastic. It looks painted
as far as the two small parts that popped off. I do not recognize them but I will give the instructions a glance and see if anything stands out
I was able to place part Y-14, but was not able to place S2 37. I already have the part in place there.That second pieces looks like it might possibly be piece S2 37
if so that piece goes into the maintenance well on page 28 in the instruction manual
not sure if there is an S1 37 that is a copy and goes somewhere else
View attachment 1620240
I was able to place part Y-14, but was not able to place S2 37. I already have the part in place there.
Yeah, I've got that one on there already. But whatevs, it's just one small part. If you find another location for the part, though, that would be good.I looked over the sprues and instructions and have not found a duplicate part (does not 100% mean there is not one, just I could not find it)
Might be some other part I am missing that is very similar but not quite the same
I grabbed a picture of the one I did find to show it's placement
This is in the top round well on the right side by the cockpit
Unfortunately if that is already in place then I am at a loss for where that unmatched part goes
View attachment 1620570