Back from hunting on Endor (ROTJ helmet)

Nairod

Well-Known Member
Long time quite....

And again I played with CFO toys ^^

Base kit: ABS stunt helmet from Cameron Oakley molds.

All the accessories as close as possible to the real deal (screen printed decals, machined mic tips, s shapped rubber neck trim, etc...)

And the final weathering for the Endor dirty look in all its glory.

JuiJqtum.jpg
YI0ASnOm.jpg

87Sk0OAm.jpg
AtadpMUm.jpg
 
Last edited:
Yes that's the screen printed details. As for the originals, those were part of a resin cast of a screen used ROTJ helmet (which is no longer in my collection).
So it will be hard to make a comparison.
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top