woohoo!
tried a pull with the clear plastic earlier, i was right to modify the grooves, much better result. came out with the right amount of definition and is tough and flexible,
its the same plastic as soda bottles so this stuff is pretty much indestructible.
its kinda hard to photograph something clear but here are some quick pics.
the ONLY issue i have is i am struggling to fit the buck onto my vac table, there is a curved flange around the edge, this should be no issue as its concealed inside the head.
its actually better to have this as it will give a better fit and something to bond it to the head.so i would NOT trim this off. i intend to use clear silicone as a bonding agent to the head and the neck ring.. i think if you used the likes of superglue you might get that fogging from the fumes, something you don't want on clear plastic..
the white one is the one i did last week, the lines are not as defined hence me going back and reworking the buck. sorry for the pics. i will try and get a shot of one attached to casting over the weekend. overall i'm very happy how it turned out.
-z