So I decided to start on the interior hold section. I was gonna get the Shapeways bunk but I realized I had over 1k in my Shapeways cart between the various Falcons so I need to mod existing stuff as much as possible.
The seats needed to be ANH which has the movable bench section. Sometimes it's tight next to the other seats and some time there is space.
The main bench has 5 big pieces and 3 small ones. To cut them off as Deago has them you end up with the wrong number of cushions and a skinny one on the end. So I added to the bunk end wall so it came out even.
Then I decided the bunk looked wrong so I chopped it off and am going to re-center it and add more walls space on either side. There is some space on each side in the film so it will match.
Still messing around with the top of the bunk.
Raised the bunk/back of bench part so the back cushions sit lower to show the control panel.
Used Tamiya Deck Tan for the cushions. Perfect match for the cushion and hall padding.
Used TamiyaWooden Deck Tan for the chairs. Again good match. A little Walmart hobby black, my fingers and a baby wipe and presto. Aged.
Gonna repaint the hole interior dark gray and then the rest of the cushions in the Deck Tan as the cushions are too black.
Too much wall to the left
Not now
Repainted cushion next to stock Deago hall pad
Prepping for cushions. These are just the indents. They are now covered with puddy and the cushions will be bake clay.