Obi-Wan ANH Light Saber Hilt Measurements

maton

maton

Well-Known Member
Hi, I was wondering if someone could please tell me or point me in right the direction of the overall hilt length and also the diameter of the sink knob of an Obi-Wan ANH Light Saber? I have searched on here but couldn't find the answers.
 
Hey maton ! I only have a full Roman's Obi-Wan Mk1 FX, but it measures out at 10-31/32".

The REAL Armitage Shanks Sink Knob is 1-49/128" Tall, and 1-123/128" in Diameter at its widest (across the face of two of its opposite cubes).

I hope this answer you questions a bit!
 
Last edited by a moderator:
Ridire Firean said:
Hey @maton ! I only have a full Roman's Obi-Wan Mk1 FX, but it measures out at 10-31/32".

The REAL Armitage Shanks Sink Knob is 1-49/128" Tall, and 1-123/128" in Diameter at its widest (across the face of two of its opposite cubes).

I hope this answer you questions a bit!
Click to expand...

Thanks so much! That's very helpful. I appreciate the reply. I have been looking recently at Roman's Sabers! They do look awesome. :)
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

13doctorwho
Obi WAn ANH Stunt Lightsaber Question
Replies
2
Views
457
13doctorwho
13doctorwho
Anakins father
Master Replicas Obi-Wan lightsaber materials
Replies
4
Views
588
Anakins father
Anakins father
IndyFanChuck
Building an Old Obi Wan ANH Lightsaber questions
Replies
14
Views
1,627
TridCloudwalker
TridCloudwalker
13doctorwho
Kenobi ANH Stunt(ish) Lightsaber
Replies
1
Views
494
SethSolo510
SethSolo510
Wells
Obi-Wan AOTC Lightsaber, chromed resin or aluminum
Replies
2
Views
722
DRambo87
DRambo87
Back
Top