Me and my friend cody on here wanted to do the EVA suits from alien. so the research began. we found a ton of info in Ritch's and steve's thread on the suit they did in 09. tons of info in that thread. Can't thank them enough for the info they found and shared.,
here is the link.
https://www.therpf.com/showthread.php?t=34659&highlight=alien+environmental+suit
Now we had a good start but some things we are still figuring out. we are scratch building the entire suit. we bought the model kits used for the greebs and will be lazer cutting parts also.
we just started on the armor and pack. still waiting on the dome i ordered which is 16 inches in diameter and 8 inches deep. i will start the helmet once i get the done.
the whole thing started out as drawings and going from there we started building parts.
drawings like this.
here are the gloves for kANE.
here are the gloves and boots i picked up for dallas. the gloves are wrong so they could be used for someone else. boots are close.
here are the model kits used for the helmet greebs and some of the parts. lots of parts in both kits. also from the mclaren kit some of the parts were used on the wrists parts. i bought a hood scoop for one of the greebs that is not in either kit. and there are some parts we cannot figure out.
parts used from the space 1999 hawk kit.
some of the parts used from the mclaren kit.
here is the start of the pack. using 4 inch pipe. the knobs are 3d printed and the correct buttons ordered.
here is the start of the chest and shoulder armor and greebs.
still have long long way to go but this is our start. thanks for looking and if you have info you would like to share to help us with this build please do so.
here is the link.
https://www.therpf.com/showthread.php?t=34659&highlight=alien+environmental+suit
Now we had a good start but some things we are still figuring out. we are scratch building the entire suit. we bought the model kits used for the greebs and will be lazer cutting parts also.
we just started on the armor and pack. still waiting on the dome i ordered which is 16 inches in diameter and 8 inches deep. i will start the helmet once i get the done.
the whole thing started out as drawings and going from there we started building parts.
drawings like this.
here are the gloves for kANE.
here are the gloves and boots i picked up for dallas. the gloves are wrong so they could be used for someone else. boots are close.
here are the model kits used for the helmet greebs and some of the parts. lots of parts in both kits. also from the mclaren kit some of the parts were used on the wrists parts. i bought a hood scoop for one of the greebs that is not in either kit. and there are some parts we cannot figure out.
parts used from the space 1999 hawk kit.
some of the parts used from the mclaren kit.
here is the start of the pack. using 4 inch pipe. the knobs are 3d printed and the correct buttons ordered.
here is the start of the chest and shoulder armor and greebs.
still have long long way to go but this is our start. thanks for looking and if you have info you would like to share to help us with this build please do so.
Last edited: