Gravity pour silicone glove question

P

P Bailey

New Member
Hi all, I'll be making silicone gloves and I'm doing a gravity pour with bleeders. It will be cast upside down... fingers down. My question is about the pour spout... it will be up the arm close to the elbow... Do I need one on each side/2, or is one all I need? Any info is appreciated.
 
with bleed holes you should not. after the first casting, it will tell you were your air pockets are if you missed any. just have clay to plug bleeder holes as the mold fills. don;t plug them right away to let air get out. hope this helps
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

ERen89
Silicone mold options
Replies
19
Views
1,438
DarkHelmet
DarkHelmet
UncleSi
Wrong silicone for head cast
Replies
4
Views
593
UncleSi
UncleSi
ERen89
Silicone mask core guidance
Replies
3
Views
910
udog
udog
cricketcos
Mask Material Question
Replies
1
Views
319
kickman88
kickman88
kdub74
Mask Making Question
Replies
3
Views
557
Mottrex
Mottrex
Back
Top