TRON: Legacy identity disc

Thread starter stefwill
Start date Jan 8, 2014

stefwill

Well-Known Member

RPF PREMIUM MEMBER

Jan 8, 2014

Given that I don't have access to a 3D printer, CNC or any of the really nice toys, I mean tools...
I've decided to sculpt an Identity disc. I'm planning to start with Tektonten's pep file then resin and Bondo and carve the details.
I then plan to cast it and fit it with LEDs etc.
Just wondering if anyone has a good set of reference images to get good measurements of the fine details.

Cheers and beers
Stef

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.