gt350pony66
Master Member
I had so much fun doing this one, I'm thinking I want to do another later in the year. I was giving some thought to this issue last night...What if, you were to take the lower panel that the bridge face attaches to, file it back, keeping the panel mating angle, then shave the two sides to match. then just file all the mating surfaces to match till it fit without any gaps? it would have to be precise and a bit at a time and rechecking, but that would achieve the goal, would it not?
Yeah, the problem is not just that the bridge needs to be angled down, it's that the lines/angle of the neck are wrong. All the lines should be parallel with the top of the main hull, but instead the run parallel with the trench.
View attachment 789084
http://www.modelermagic.com/?p=19630