You must mean the magazine well plate, not the extractor. The extractor is on top of the bolt and it's what pulls spent shells from the chamber as it cycles.Nice to see you posting again, Vanitas!
I'd recommend checking out Matty Matt's ESB DL-44 Accurized Denix thread:
https://www.therpf.com/showthread.php?t=240719&page=8&highlight=matty+matt
I consulted his thread a lot when accurizing my Denix for my GK build ... check that out if you're inclined!
https://www.therpf.com/showthread.php?t=216859
Boba Debt has been running a Denix accurization service for the last few years or so, where he batch-sends them off to a machinist to have the side pockets milled deeper, extractor milled, etc., though I believe this last run was his final one.
Field Marshall is currently offering some accurized Denix's on his website with some pretty cool features ... an actual removable extractor plate among them!
http://www.warmachinepaintball.com/...machined-stardard-denix-replica-noncutbarrel/
There have also been a few more recent Denix builds that have taken things to new extremes, though I can't seem to find them right now! Serial numbers stamped in, vintage grips fitted ... very impressive!
Hope that helps.
MB
I think Field Marshall's extractor detail is just a milled out shape of the extractor, but correct me if I'm wrong!
Sent from my VS996 using Tapatalk