Update time
first thing I did was to use 2 strong magnets to hold the magazine in place, the clip for holding the magazine in place was only for show, as you can see I stuck one in the mag and the other in the mag holder, when the E-11 is tilted and shaken it won’t drop out
I wanted to add the little detail to the bottom of the magazine, I searched all my junk pile for a small ball bearing but I couldn’t find anything that would work, but I then found this little plastic ball that my wife has donated for the build ( Shhhhh she doesn’t know she has donated this ) I cut a hole in the bottom of the magazine and glued it in place from the inside as I didn’t want it to stick out to far
What she she has unknowingly donated is or was the end of her stitch un-picker from her sewing box ( I will search high and low in anything for my build )
Primed, painted and fitted
Hopefully, fingers crossed I should have the rest of my bits back for my grip and trigger section very soon
The next job I’m going to do is put little screws in the end of the scope
Like this
I wonder if my blaster would get a pass from the 501st ? Not that I would take it out trooping, this is going pride of place on a stand, oh by the way !! that’s another thing I’m going to design is a stand, something a little bit different to the normal stands out there
oh and another thing ( I nearly forgot ) who makes good plaques ? I would like one for my E-11 blaster
Thats all for tonight
thanks for looking