robbytherobot
Active Member
Hey guys, currently in the process of building a cryocan, I've been scouring the Blu-Ray for any and all clear pics of the can, rack, and tubes, and I noticed something that never gets mentioned, and have never seen on any of the existing replicas, not even Rylo's. There's a conical section on top of the lower disk of the rack, drilled through, where the replicas are all flat. It's not well shown but you can first see it for a few frames when Dodgson puts it away.
You can see the profile better when Nedry starts filling it with tubes.
There's also a closeup where one of the branches joins the disk.
Not sure if this is usually left out because of the difficulty of machining it or if it's just gone unnoticed all these years. Like I said, it only appears for a few frames here and there, and it's almost impossible to see with the tubes in. But it's kind of a significant detail! I can't be the first to have noticed this, right?
I've also noticed that the bottom of the can is concave like a regular aerosol can, not flat, and seems to have a lot number/date etc. printed in the center. It does have to get through customs, after all...
You can see the profile better when Nedry starts filling it with tubes.
There's also a closeup where one of the branches joins the disk.
Not sure if this is usually left out because of the difficulty of machining it or if it's just gone unnoticed all these years. Like I said, it only appears for a few frames here and there, and it's almost impossible to see with the tubes in. But it's kind of a significant detail! I can't be the first to have noticed this, right?
I've also noticed that the bottom of the can is concave like a regular aerosol can, not flat, and seems to have a lot number/date etc. printed in the center. It does have to get through customs, after all...
Last edited: