My wife and I are working on Link and Zelda costumes. I wanted to make Zelda's Bow from Twilight Princess for her, so I 3D printed it and used Arduino and Neopixels for the electronics. This was modeled in 123D Design and printed on a Rostock Max v2 in Hatchbox silver PLA filament. It runs on an Arduino Gemma and 3 AAA batteries.
I'm in a contest on Instructables to win a 3D printer, so if you feel that my entry is worthy, a vote would be very much appreciated!
Here is the Thingiverse link, but all of the build instructions are on Instructables.
Videos:
Images:
I'm in a contest on Instructables to win a 3D printer, so if you feel that my entry is worthy, a vote would be very much appreciated!
Here is the Thingiverse link, but all of the build instructions are on Instructables.
Videos:
Images:
Last edited by a moderator:
