Tan Djarka
Sr Member
What is the emitter made of?
PVC pipe, sheet styrene, and a Tonka truck wheel for the "ring of holes".
What is the emitter made of?
Looking stellar sir! Is that grenade the same bunch of PVC rings carved up
DIY calc bubble strip made from a piece of plexi glass and clear rubber bumpers.
That’s actually really useful. I’m in the process of doing a 3D printed ESB Vader hilt and I was wondering how to do the calc strip short of just buying a replica from somewhere, seeing as how it’d be difficult to print something so clear.Get yourself some 7mm clear round cabochons. They're the right size and they're crystal clear.
That's what I normally use, but I ran out (see the refurbished clamp pictured above). What's there is effectively a place holder.Get yourself some 7mm clear round cabochons. They're the right size and they're crystal clear.
Thanks. Honestly, they seem to look a bit better in the pics than in person. I've probably thrown away as many failed attempts as I have good ones. It's usually the last bends that hold the circuit board or bubble strip that gets me!I will never get over your clamps, freaking great folding.
You know, when I started, I really tried hard and never achieved your scratchbuilding skills.