ShadowAssassin
Active Member
COSTUME IS FINISHED - PICTURE UPDATED
A couple of weeks back I began the early stages of an Utrom Shredder build. I wanted to get enough together before I started posting progress pictures. Right now it's at a point where enough of it is together that it is beginning to take shape so I will start to show updates on it.
I have yet to do any work with an under suit, parts are also only temporarily in place and will be better fitted in the final product.
The whole suit has been made out of 6mm EVA foam other than the abs which I have used 10mm foam that I have rounded off the edges with a Dremel.
I was unable to use the same foam for the spikes as I have used for the rest of the suit, the other side of the rolls of foam I use all have a design on the opposite side, I needed a smooth surface on both sides. I ran out of this foam and will need to get more to finish the shoulder spikes.
With this photo it was just to see for myself what needed work. The abs section will not be as loose as it's shown here, I plan to have it attached to the undersuit with velcro completely separate from the chest to give me as much movement as possible. The torso is connected at the back via a zip to get on and off.
A couple of weeks back I began the early stages of an Utrom Shredder build. I wanted to get enough together before I started posting progress pictures. Right now it's at a point where enough of it is together that it is beginning to take shape so I will start to show updates on it.
I have yet to do any work with an under suit, parts are also only temporarily in place and will be better fitted in the final product.
The whole suit has been made out of 6mm EVA foam other than the abs which I have used 10mm foam that I have rounded off the edges with a Dremel.
I was unable to use the same foam for the spikes as I have used for the rest of the suit, the other side of the rolls of foam I use all have a design on the opposite side, I needed a smooth surface on both sides. I ran out of this foam and will need to get more to finish the shoulder spikes.
With this photo it was just to see for myself what needed work. The abs section will not be as loose as it's shown here, I plan to have it attached to the undersuit with velcro completely separate from the chest to give me as much movement as possible. The torso is connected at the back via a zip to get on and off.
Last edited: