Transformers - Decepticon Emblem - Holiday Project!

G17RDY

Sr Member
Hello,

Decided over the holidays to finally get a small project i've had in mind for a while now done.

I really wanted a Transformers Decepticon Emblem for my car grill, but could find any on ebay that were the right size, the correct design or didn't look like cheapo plastic. So i decided to create my own!

The original was constructed from styrene, i then mold and cast using an aluminium filler in the resin. The results were just what i was looking for, they have a nice weight and when polished up really look metalized!!

May be offering up a few casts in the junkyard if there is any interest!!

Original Styrene:
b28014d5.jpg


Resin Casts:
2a8e8075.jpg


680cfd3e.jpg


26d72316.jpg
 
Has an idea the other day - Cast an emblem up, and stuck it onto the front of an A5 and A6 sketchbook - think it came out pretty nice!!

60bf7661.jpg


a4ffc30b.jpg
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top