I will be Installing 2 layers of medium tint plastic lenses on a P1 stunt Bio.
These lenses have a removeable protective film on both sides.
The thickness of both pieces combined is about 1/16".
Below is a picture of the inside of a P1 stunt Bio from George (Ptgreek).
I will be using Aves 2 part Apoxie Sculpt in silver/grey to build up the lip around
the eyes. This will give me a good surface area to hot glue the lenses in place.
Mix equal parts of A and B together. This stuff has about a 1 hour working time
before it starts to harden.
Create a flat surface area around the eyes about 3/16" wide.
Once the Apoxie Sculpt has cured (about 24 hours) put the first lens
in place (DO NOT remove the protective film) and trace around the eyes.
Using a good pair of scissors, cut the lens to size.
Place the cut out lens over the second piece then trace and cut.
Now remove the protective film from the front side of the first lens.
Leave the film on the back side for now.
Using a hot glue gun, spread a small amount around the lip.
Carefully put the lens in place. Make sure the exposed side of the lens is facing out.
Once the lens is securely in place remove the protective film from the back side.
Now just repeat the process with the second lens. Be careful not to get any hot glue
on the visible part of the lens.
Once both lenses are in place you can use more hot glue or Apoxie Sculpt
around the edges to create a stronger bond.
These lenses have a removeable protective film on both sides.
The thickness of both pieces combined is about 1/16".
Below is a picture of the inside of a P1 stunt Bio from George (Ptgreek).
I will be using Aves 2 part Apoxie Sculpt in silver/grey to build up the lip around
the eyes. This will give me a good surface area to hot glue the lenses in place.
Mix equal parts of A and B together. This stuff has about a 1 hour working time
before it starts to harden.
Create a flat surface area around the eyes about 3/16" wide.
Once the Apoxie Sculpt has cured (about 24 hours) put the first lens
in place (DO NOT remove the protective film) and trace around the eyes.
Using a good pair of scissors, cut the lens to size.
Place the cut out lens over the second piece then trace and cut.
Now remove the protective film from the front side of the first lens.
Leave the film on the back side for now.
Using a hot glue gun, spread a small amount around the lip.
Carefully put the lens in place. Make sure the exposed side of the lens is facing out.
Once the lens is securely in place remove the protective film from the back side.
Now just repeat the process with the second lens. Be careful not to get any hot glue
on the visible part of the lens.
Once both lenses are in place you can use more hot glue or Apoxie Sculpt
around the edges to create a stronger bond.