norbigomba
New Member
Hello!small version of template for forum viewing...
Link to full size image...
http://www.spritestitch.com/wp-content/uploads/2010/08/fullpattern.png
I needed two pages to print it, so I printed the left half then the right half on separate pages and lined em up after.
I started using the guide thingy for the dremel that keeps it at a level height, so that you what you engrave in is all level...but I had heaps of trouble with it. I ended up just holding the dremel at a 45 degree angle and freehanding the whole thing. it worked much better.
If you get this message, can I get the full size image? The link is sadly broken.
Please send it to here, because i will never find this site again: norbigomba@gmail.com
Thank you for your cooperation!
