Thanos bust

J

Jeje

New Member
Hi everyone!

I've start ths sculpt of thanos bust.
I use oil clay. When the sculpt will be finished, i'll make a mold and cast in silicon.

Here where i am...
Your feedback are welcome.
ImageUploadedByTapatalk1433625621.452664.jpg
ImageUploadedByTapatalk1433625643.826519.jpg
ImageUploadedByTapatalk1433625669.274729.jpg

ImageUploadedByTapatalk1433625696.139722.jpg

Regards
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

MAKE BELIEVE
3D Printed Snake Plissken bust (Finished)
Replies
2
Views
505
MAKE BELIEVE
MAKE BELIEVE
MAKE BELIEVE
Lord of Darkness / Legend - 3D printed bust - Finished
Replies
4
Views
684
MAKE BELIEVE
MAKE BELIEVE
MAKE BELIEVE
Bela Lugosi / Dracula 3D printed bust - Finished
Replies
3
Views
853
MAKE BELIEVE
MAKE BELIEVE
MAKE BELIEVE
Bride of Fankenstein 3D printed bust - Finished
Replies
5
Views
986
MAKE BELIEVE
MAKE BELIEVE
Iskelderon
Saber Rider - Bronco Buster
Replies
2
Views
1,305
Iskelderon
Iskelderon
Back
Top