Starting to believe these were just custom made in house...
No way. These new T-tracks are taller than all of the ones mentioned.
I just saw the close up pic of Finns pocket...
These are all new. Close in width to the original. But unless my eyes are playing tricks, the "fins" that stick out are taller and/or skinnier...
I have like 4 sets of "close to" t-track... Those aren't Saberfreak or Gino.
I agree. You can tell that those fins are very tall and hardly tapered, unlike the OT T-tracks (and mine)
Who's circuit board is that!!! It looks just like Roy's!!!
Nevermind. Looked at the full pic again. Not possible based on how he is holding it.
Agree, they seem to almost reach the height of the top portion of the sidebars, mine are about 3/4 of that height.
- - - Updated - - -
I wonder if it´s rounded or square.
Can we agree on that the hero has plain rivets, whereas the stunt may have rusty hex screws?
I do agree those look more like rivets than a button hex screwand I was only teasing a bit. The hex screws of the stunt does look more domed and seem to have a larger hole in the center.
View attachment 527983
Roy
i see a rivet in the black and white photo. the heads are much flatter then a button hex head we see on the "stunt"
One detail I noticed about the stunt - the black cap on the bottom has a lip on it that matches the diameter of the hilt, while it's skinnier above that. It looks as if it's a battery compartment/module that's supposed to sit further up into the hilt, but is hanging out partway. Maybe it was sticking out only for this shoot, and that's why there's not a black section below the grips on the promo artwork?