DeltaDesignRus
Well-Known Member
And to top it off, this detail is short, just like in T1 and the skull from the T2 teaser. There are more similarities, but I'm tired of comparing and drawing. 
T1 and T2 Endoskeleton Research Thread
- Thread starter Too Much Garlic
- Start date
DeltaDesignRus
Well-Known Member
Too Much Garlic
Master Member
Interesting. My foam skull groove stops before it reaches the large "bell" shaped indent at the temples too. Seen in the last blow-up skull picture.
Last edited:
DeltaDesignRus
Well-Known Member
Yeah, I noticed that a while ago, even in the screenshots of your scan. So you've got a very interesting artifact there! However, your skull does have some differences from T1.
DeltaDesignRus
Well-Known Member
Too Much Garlic
Master Member
Yeah, Quartz suggested the foam skull was a T2 style.
Sorry that it is upside down.
Sorry that it is upside down.
DeltaDesignRus
Well-Known Member
There should be details on the back of the skull for T1...
Attachments
Too Much Garlic
Master Member
I can take a better picture later. But here's one from another angle.
DeltaDesignRus
Well-Known Member
Attachments
Too Much Garlic
Master Member
Yeah. Mine is missing a lot of details. Washed out and softened. There are several indents that are completely filled in on mine - probably because the mold making it wasn't perfect and the casting used to be molded wasn't perfect.
But look at the inside surface of those indents. The back walls are cut out and some detailed flat plane is put there instead. Wonder what that is. I've not seen that detail replicated on any licensed or fanmade skull.
But look at the inside surface of those indents. The back walls are cut out and some detailed flat plane is put there instead. Wonder what that is. I've not seen that detail replicated on any licensed or fanmade skull.
DeltaDesignRus
Well-Known Member
I only saw it in the T2 teaser, and it's very hard to see there. So far, I haven't found any more details about it.
Too Much Garlic
Master Member
Yeah. Could be interesting to see the EMP Museum ones.
ghostman
Well-Known Member
I believe that is degraded shrinkage due to copying.
I don't have a suitable photo right now, I'll take one later.
M1 will also be re-done photogrammetrically after April.
It was 4K before, but will be re-shot with a 6K camera.
AI upscaled this one x4
Too Much Garlic
Master Member
Thanks for the larger picture. I can now see what I should have done different on those nut parts of one of my sculpts. I'll redo it and see if it turns out better.
DeltaDesignRus
Well-Known Member
Don't forget that a neural network, when upscaling, distorts many details, some it diminishes, while others it exaggerates. For example, it can make rounded edges sharper, etc.
Too Much Garlic
Master Member
Certainly, but thanks for the heads-up.
Anybody know this guy?
www.yourprops.com
Anybody know this guy?
Terminator 2: Judgment Day Planet Hollywood Arnold and Endoskeleton replica movie prop
The Arnold is an original Planet Hollywood figure. Many of the original Winston employees worked on these using the original Winston molds/props. Featuring original Bates leather Jacket/Pants, m ...
THIS.
Which is why I make sure to mention it's upscaled.
Even with high-res photos you have to think about lens distortion. With AI upscaling trust goes completely out the window.
killuminati89
Active Member
Does anyone know where this skull comes from?
DeltaDesignRus
Well-Known Member
The skull in shape and CPU port resembles Sideshow.
Last edited:
