Billy the Hero
Member
This is my build of spinning Peridot from Steven Universe! It was my intention from the start to let her spin like this.
I started with modeling in Blender with screenshots from the show, making sure that I create a male-female peg to allow my figurine to spin later on.
Here it is printed, in PLA at 200 microns.
I then painted her in Vallejo model paint, sprayed a clear-matte coat, and applied my custom decals, pretty pleased with how she turned out so far!
But again, I really want her to spin, so I utilize a high-torque 70RPM DC motor I had laying around. Also used a green LED-Latching Switch just because I wanted to get fancy. At this point I'm nearly done, I just need to figure out a reliable way to stick my figurine to the DC motor! Any suggestions for that would be appreciated
Attachments
Last edited by a moderator:
