[SOLVED] I ****ed up in blender while doing retopology. Please help!


New Member
Hello all!

So, I was doing a retopology of the joker mask from the dark knight. When I finished and transferred the obj in Papakura, the model was set inverted, so I'm unable to make this.

Now, when I checked in blender the backface culling in my retopology, I couldn't see the color that I have set my retopo, and it was only visible from the inside of the mask. So, I must have done the retopology inverted from the beginning.

Please tell me if there is any solution to make it normal. Thank you!
You should be able to flip the normals in Pepakura before unfolding. Otherwise PM me the file and I will take a look.

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.