Slave one fine molds with light

Thank you for looking my post



img_1725.jpg

img_1726.jpg

img_1727.jpg

img_1728.jpg
 
Hi Shinra - Thanks so much for posting these pics of the build I have done for you! And also to turning me on to this site!

To answer a few questions from users -

The panel lines were done using a sludge wash technique - a little practice and it can really bring your kits to life! Here is a great article I found that can get you started!

http://www.finescale.com/en/sitecor...port/files/pdf/d/9/f/quickeasyweathering.ashx

And as far as the Glock 17 on my table! HAHA - I guess I need to clean up my area a bit more before taking pictures! It was about 3am and I heard something in my front lawn, thankfully it turned out to be nothing = ) I hope I never have to use it, but better safe than sorry!
 
Last edited:
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top