Skin painting help


New Member
When painting my first few coats of latex onto a lycra suit, can I work on a table and do one side at a time or should I keep the skin in a hung or standing position so I can paint over the whole thing in one sweep?

Would there be any problems with the lycra shrinking funny if slowly I paint one side at a time?

Can I get away with using just latex for my first coat without distilled water to thin it?
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.