Releasing rebound 25 from rebound 25?

[toasty1231]

Hello everyone. I was trying to make a 2 part mold using rebound 25. I all ready have one half done, and im trying to do the other half. I tried to use mann ease release 200 but that just inhibited the cure. What can I use to prevent rebound from bonding with the cured rebound?

 

[Beaker]

If it is inhibiting the cure, you are applying the Rebound to fast after you sprayed the release.... the release needs to be totally dry on the surface before you apply the rubber....

 

[bookface]

What he said…I've used ease release 200 loads of time to make a 2 part rebound 25 mould. Never had a problem.

 

[TheSt.LouisKid]

And if you are still looking for other ideas I suppose the manufacturer might have an idea as to what to use.

 

[Luke0312]

As others said, I've never had any problem using ease release with R25.

What's your master made from, as R25 is platinum cure and several things can inhibit it from curing.

 

[toasty1231]

This is still not working, I waited about an hour after spraying the R25 and Its still sticky 15 hours later. This is ruining my masters...