Reflective material question (For stunt blades)

Deltaflyer90

New Member
hey guys

I have been using the standard 3M reflective tape for my OT stunt saber blades and i was wondering if there is a reflective paint that reflects and works the same way?

do they make such a paint?


Deltaflyer90
 
I'm not sure if there is reflective paint or not, I'm sure there is.
However, my dad used to paint speed bumps on roads and he would mix sand into the paint he used that caused it to reflect at night. Hope that helps a little.
 
Don't try the available reflective spray paints. I didn't get good results.

However there is reflective paint out there. Check out the glow in the dark car in Repo Man. This was a practical on-set effect. It did cost $600 can however!
wibyzj2wpyiprd6au9ur.jpg
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top