Rain stained my latex paint


Well-Known Member
I recently did an event and it happened to rain. I stayed out of it for the most part, but did get a few drops on my Latex Gamorrean Guard mask. The mask was darkened where the water made contact and left rings where it dried. You could see spots and places where the water ran down. Is there a way to protect the paint job. It's painted with Reeves acrylic mixed with latex. I mixed up a color match and retouched it, but I don't want to mess with this everytime I hit bad weather.

Any ideas? I had no trouble with any of the other latex parts staining like the mask.
Sorry that happened to you.
I bet there has to be some kind of sealer you can use that won't alter the color or shine of the mask.
Here's a picture of the damage.


This was before.

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.