Problem with a Twin Peaks ring - stone fixative?

[Lanboy]

Guys

A few years ago I bought a replica of the ring featured in David Lynch's movie Fire Walk With Me from one of our illustrious board members. This is the ring with the "Black Lodge" symbol engraved in the green stone. It's a great piece, and I wear it every day. Unfortunately the stone popped out yesterday. I recovered it unharmed (the maker actually included a spare anyway, which was great) and I'd like to repair it.

Any jewellers on the board have a recommendation?

 

[GARMANBOZIA]

I realize this is and OLD post, but I also had the same problem with mine. I, at first used, used super glue. That was a joke. So I ended up using Gorilla Glue epoxy. (Make sure its the two part epoxy) I put a tiny amount on both surfaces, then used a very small "C" clamp to hold it in place while it dried. I gave it a full 24 hours for safe measure. Needless to say, I've been wearing the ring for the past year, and its stayed in place!

 

[Lanboy]

Thanks, I ended up using a similar solution. Two part epoxy did the job. Four years later and no sign of the Black Lodge...

 

[GARMANBOZIA]

Thanks, I ended up using a similar solution. Two part epoxy did the job. Four years later and no sign of the Black Lodge...

I was wondering if you have a photo of your ring you wouldn't mind posting? I made my own, and would like to compare it to yours. Do you know if the company/person that made yours is still making them? Thanks!

 

[DrMcoy]

MEGATRON made these and they are very nice...but I believe a tad too small. I bought three over the years, one brass/bronze (gold tone) and two silvers. The first two were a little more rough, the 3rd was cleaner -- he must have done new sculpt. I'll post pics of the two I have at hand this weekend.

The one you made and one just posted by another member (made by jeweler) appears to be more accurate from a size standpoint.

Maybe Megatron would consider doing another run of larger-size BLACK LODGE rings if there was enough interest.