Predator wolf Wrist Computer/Self Destruct

What are you trying to do?

I have plans to build one from the ground up using the new Stemma/QT/QWIIC network of devices with a raspberry pi. Thing is though I have to get the devices then lay them in and get a good mould for sculpt and residual casting for a good fit.
 
i need the count down screen.. to replace this one
20220529_220830.jpg
 
Well the screen is basically a bunch of LEDs wired to a micro controller. I was looking at using an LED matrix display set on mine for each screen and the upper left one. Then a membrane on the bottom buttons. The movie unit was a bunch of analog controlled stuff with a simple micro controller pre programmed routine.
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top