Predator wolf Wrist Computer/Self Destruct

ksj

Well-Known Member
What are you trying to do?

I have plans to build one from the ground up using the new Stemma/QT/QWIIC network of devices with a raspberry pi. Thing is though I have to get the devices then lay them in and get a good mould for sculpt and residual casting for a good fit.
 

sonbill

New Member
i need the count down screen.. to replace this one
20220529_220830.jpg
 

ksj

Well-Known Member
Well the screen is basically a bunch of LEDs wired to a micro controller. I was looking at using an LED matrix display set on mine for each screen and the upper left one. Then a membrane on the bottom buttons. The movie unit was a bunch of analog controlled stuff with a simple micro controller pre programmed routine.
 

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top