Power Rangers and more


New Member
View attachment 69429

View attachment 69430

View attachment 69431

View attachment 69432
Hi board,
I'm pretty new here (just signed up lol) and I make helmets and mini models and things. My newest project is with Power Rangers. I was building a full size power ranger helmet, but after making a small version as a tester I got a load of great response over at Rangerboard of people asking me to make them one. I wanted to post a few pics here and get the opinions of people from this forum. Let me know what you guys think.
We used a smooth on resin plastic, ultracal 300 I think, and let it sit for a few hours. Are there still any interest in power ranger helmets? Even wearable one. I have a classic red ranger wearable almost done
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.