hez1
New Member
Not come across this before, and Smooth On were no help at all. My casts have for some reason started oozing after I've pulled them from the mold, which is causing difficulties painting. I've tried scrubbing with hot soapy water, no difference. Even when I do get a good coat of paint, certain spots will stay tacky. I'm not using mold release, so that's not it.
It can be slightly cold in my shop, could that be causing it? I can see it affecting cure time, but I haven't heard of it causing oozing before. Is it a bad batch of resin? It's the same smooth on 320 that I've always used. There's no pigment or filler involved either.
It can be slightly cold in my shop, could that be causing it? I can see it affecting cure time, but I haven't heard of it causing oozing before. Is it a bad batch of resin? It's the same smooth on 320 that I've always used. There's no pigment or filler involved either.