Predator Resin Model - How to Join together

MortonPrice

New Member
Hello all, looking for some advice on Resin models and how to join the limbs together.
i have purchased 1:3 scale Predator 2 Kit which has come in pieces and i have no idea how to join it all together.
The torso is really heavy. A solid piece of resin.

1) I have no idea how to join the legs to the torso.
2) How to join the arms to the torso

I would be really grateful for any advice.
 

Attachments

  • Predator Resin Kit.jpg
    Predator Resin Kit.jpg
    809.7 KB · Views: 626
  • Predator Resin Kit2.jpg
    Predator Resin Kit2.jpg
    826.5 KB · Views: 495
I would dry drilling very small holes to add some pins, then affix it all together using a resin based epoxy, then sand any excess around the seams.
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top