Nike Mag V2 Mod Discussion (Page 58 Shopping List)

Status
Not open for further replies.
Re: Nike Mag V2 mod discussion and builds

I think about same as the 750mah ones 3-4 hours and your fine I think
 
Re: Nike Mag V2 mod discussion and builds

nik what diode and pin should i buy and where should i wire it to?
 
Re: Nike Mag V2 mod discussion and builds

type this in ebay and it will be the first one that pops up.

10 pcs DC Power supply Jack socket 3.5 X 1.1 mm

for the diode, I bought a zener diode from a local store in orlando. I explained what I needed them for and the guy at the place got em for me. I wish I could be more of a help on that one. sorry bro
 
Re: Nike Mag V2 mod discussion and builds

I was referring to a 9v setup using 1x100ohm resistor, thing is I've used up 3x9v batteries on a setup now the last few days with no resistor and not one led has blown so using 1x100ohm resistor was really a just incase but I honestly don't understand why we need them installed. Surely by now if this was right a led would have blown? As none have yet I honestly don't get why people are using resistors for 9v setups. Maybe I'm just lucky lol?

What LEDs did you buy out of curiosity??
 
Re: Nike Mag V2 mod discussion and builds

My reason for asking is that if the LEDs are wired in parallel and connected to 9v...then each resistor is getting 9v Put through it...unless they are 12v leds then there is no way those LEDs should be working.

The only way they would not die would be if they are actually wired in series.

Either im just having a very blonde day today! or everything I have been taught about electronics is wrong. They only have a max forward voltage of 2.2v (well around that). So chucking 9v through them is clearly going to break them
 
Re: Nike Mag V2 mod discussion and builds

any guys in the uk with some good switches available? nobody has any judco switches over here and the ones in maplin were awful.

if anyone has any judco switches i will gladly buy about 10 of them.
thanks
 
Re: Nike Mag V2 mod discussion and builds

You can buy them from "digikey UK" but technically there is no digikey UK and they come from America anyway.

Ive had a look around on Farnell and RS and they dont seem to do any "flat" switches that are good enough.
 
Re: Nike Mag V2 mod discussion and builds

hi guys !

first of all i'm new here but im following all the mod's and things for a long time and i thought its gonne be time to make myself a pair (excuse for my bad english)

i want to order a pair of air mags at aliexpress from karin chen like u recommended
but im having a problem DHL and fedex don't send electronics that what karin said
and EMS will hold my package.
Does someone here had the same problem and find a way to get them in to europe? (the nederlands)

thanks im hoping for a reply!
 
Re: Nike Mag V2 mod discussion and builds

You can buy them from "digikey UK" but technically there is no digikey UK and they come from America anyway.

Ive had a look around on Farnell and RS and they dont seem to do any "flat" switches that are good enough.

yeah its quite shocking!

no flat switches in the entire uk!

unbelievable!
 
Re: Nike Mag V2 mod discussion and builds

Nice thanks for confirming Nik, so with 750mah were looking at 6hours plus, hopefully!!

i forgot to ask

what are you guys using to tape up the middle bit of the Sole EL cutouts?

do you just use grey electrical tape to give the 2 half circle shapes in the middle?
 
Re: Nike Mag V2 mod discussion and builds

This is a dumb question but what exactly do i need the diode for?
I know it blocks current or forces it to go in one direction but what will happen if i dont use one?
 
Re: Nike Mag V2 mod discussion and builds

This is a dumb question but what exactly do i need the diode for?
I know it blocks current or forces it to go in one direction but what will happen if i dont use one?

You'd hate for the power to go from the charger back to the charger. I imagine that could be ugly.
 
Re: Nike Mag V2 mod discussion and builds

BTW, I have 2 of these on order. I will how they do:

Gift-Battery-Battery-9V-Rectangular-Recharge-500-times-b-83097.jpg
 
Re: Nike Mag V2 mod discussion and builds

Those look cool. Let us know how that goes. Off topic, but on eBay a pair of RDs is set to sell for about 500 with one of the straps not working. Hate to pass up on that. Also, there is a pair of v2 selling with light up straps, could it be an RPFer who made em?
 
Re: Nike Mag V2 mod discussion and builds

Off topic, but on eBay a pair of RDs is set to sell for about 500 with one of the straps not working. Hate to pass up on that.
Yeah saw those. Are they genuine when a ceramic MAG is listed $249?
 
Re: Nike Mag V2 mod discussion and builds

Off topic, but on eBay a pair of RDs is set to sell for about 500 with one of the straps not working. Hate to pass up on that. Also, there is a pair of v2 selling with light up straps, could it be an RPFer who made em?

Yeah saw those. Are they genuine when a ceramic MAG is listed $249?

I guarantee these are V2's and he is scamming people. The seller states that he will send pics upon completion of the auction. If that isn't fishy, I don't know what is. We all know that the V2's don't have light up straps. It's just tricky wording he used. Read it again...

ALL LIGHTING WORKS EXCEPT THE NIKE LIGHT STRAP ON THE FRONT STRAP NEVER WORN THIS AUCTION IS FOR SHOES ONLY NOT THE CERAMIC UNIT SHOE. PHOTOS WILL BE SUPPLIED AT THE END OF AUCTION



I just sent that seller a question:

Are these a pair of the official 1510 pair of NIKE MAGs that were auctioned off in 2011 or are these the Chinese Knockoffs that don't have the light up strap?
 
Re: Nike Mag V2 mod discussion and builds

0 feedback, 1 picture, price 5 times lower than the average, all caps description... no way thats legit, and if you believe it is, then I also believe that you were born at night, and that it was last night :behave
 
Status
Not open for further replies.
Back
Top