newbie needed some advise

Joshwood

New Member
#1
New to this looking to find something to occupy my time while its both cold and between night shifts what's the best foam to use when using the foam patterns got some 1/2 inch foam pva glue and a lot of cutting equipment any advise about better foam to use on both the helmets and the armor itself seen some amazing stuff on here loads of inperation​
 
Last edited by a moderator:

Sym-Cha

Master Member
Hi Joshwood ... welcome aboard ... I think it would become a lot easier if you explain which helmet and armor you're talking about so then you'll attract the right crowd to come to your aid ;) Then there's also the 'popular franchise' section perhaps you meant to post your inquiry there? And if you mention your character in the title ... you'll get the picture, right :)

Chaim
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top