Munson P1 Head Sculpt

munson

New Member
I've always liked the Morris head and with the more than possible link to the original screen used head, I thought I'd base my P1 mask solely off of the Morris Head and screen used pictures.  I also thought that since the Snake and P2 Elder mask from "Predator 2" were the original mask with either latex additives and P2 mandibles, I thought I'd sculpt them as well.

I should be molding and casting next weekend.

IMG-20140907-00344.jpg


IMG-20140906-00340.jpg


IMG-20140906-00339.jpg


IMG-20140906-00341.jpg


IMG-20140907-00347.jpg


IMG-20140907-00345.jpg


IMG-20140907-00346.jpg


IMG-20140907-00349.jpg


IMG-20140907-00351.jpg
 
Great sculpt, those P2 style lower mandibles make that thing even meaner!  All these sculpts popping up are great, can't wait to see that first pull!
 
It's been a while and I finally was able the mold it...the second time.  The first molding attempt didn't work out so well, but the second time went much better.  The final mold is pretty decent, but it could've been better.

Here's the pics I have or now and I'll upload more later.  It does fit the P1 Stunt like a glove!

all three.jpg


p1 bio - Copy.jpg


p1 bio 1.jpg
 
I hope to start painting this sooner than later, but I need to pick up some inks first.  I'm out of the colors I need.
 
Finished the paint work, but I still don't have a quality camera. I'll try to take some better pics during the day to use some natural lighting too. Here are some pics until I can obtain a camera.

full paint 1.1.jpg


full paint 2.2.jpg
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top