MSE-6 Mouse Droid Build

[Sith Lord]

These are the boards I used

http://www.ebay.com/itm/180mm-x-300...board-2-Pcs-/331639506890?hash=item4d374147ca

Not 100% accurate, but they'll be painted black so no-one will know... Because I went for a slightly smaller scale build I had to compromise with some of the components. There are some items that come up on Astromech from time to time

http://astromech.net/forums/forumdisplay.php?63-Other-Part-Runs

Keep your eye on there, but tbh, they seem quite expensive most of the time

 

[Sith Lord]

The sides were just standard 14 and 16 pin IC Pins and sockets. Others like the resistors, I had no idea bout the sizes but the were dirt cheap from China so ordered a few. Honestly can't remember which ones I actually used - depends what looked better.

The main tubes on top were 8mm aluminium. But depending on what scale you're building, the size of these will vary. If you're building the same scale as I did, pm me for any specific items you need. (half my eBay links are probably no longer valid). Others, like in one of the pics was a whole bunch of random tubes, etc from the local wobbly store. As I mentioned, even with wastage it only cost me $70- compared to $350 quoted from Moncal.