Skigro
Well-Known Member
Print is done. This time I printed at .1 layer height. Turned out amazing. Everything fits together. A few pieces are a bit loose but a little glue or tape on the connection points holds it together well.
Only issue is the clamp is too small. So I need to go back and modify the diameter of the booster and clamp so everything fits together correctly. But the current clamp and all its parts fit together nicely.
Almost done with this project. Yay!
Sent from my iPhone using Tapatalk
Only issue is the clamp is too small. So I need to go back and modify the diameter of the booster and clamp so everything fits together correctly. But the current clamp and all its parts fit together nicely.
Almost done with this project. Yay!
Sent from my iPhone using Tapatalk