Kylo Ren Helmet Sculpt - (Old School Version 2 beginning pg17)

[Sevv]

very nice!

 

[Homer]

Could you post a full frontal view of the helmet Master Ed ?

 

[MasterEdi]

Could you post a full frontal view of the helmet Master Ed ?

Sure, here you go Homer!

 

[Padawan311]

This looks great! Impressive. Most impressive! Nice work!

 

[Yeebeme]

v2 is looking absolutely excellent mate, hopefully will get a lot less complaints from people about the size even though v1 is so beautiful, think I'll pick one up when you're ready to start a run

 

[Homer]

Sure, here you go Homer!
View attachment 529780

It looks too cool ! Can't wait to see it in person !

 

[j97e]

Will V2 have the bottom lip, similar to the one on Phasma helmet?
View attachment 530204

 

[dday]

Will V2 have the bottom lip, similar to the one on Phasma helmet?
View attachment 530204View attachment 530205

Unless we have some secret photos, there is nothing to say that this exists It's the mic tip all over again.

 

[j97e]

It exists on my 18" Jakks Kylo helmet.

 

[MasterEdi]

Will V2 have the bottom lip, similar to the one on Phasma helmet?

I've debated about putting it in.... Right now I'm leaning on not putting it in until overwhelming evidence says I should.

 

[j97e]

In any event, I will be getting one whenever they are offered

 

[Gyurma]

V1 Size:

11" wide x 11" high x 14" long

 

[mothman]

Great work so far!!! very talented!!

 

[MasterEdi]

Small run info posted in project runs... http://www.therpf.com/showthread.php?t=247077

 

[cld213]

Pm sent

 

[cld213]

Ive seen the photos I posted here for MasterEdi show up in no less than 3 places used for selling their helmet lol

 

[MasterEdi]

The first raw cast out!

.... A little cutting and sanding...

 

[kev1969]

Fantastic job again, can i order one?... please

 

[MasterEdi]

Sure you can... Here is the info http://www.therpf.com/showthread.php?t=247077

Read it carefully, and remember my helmet is the big one! Lol, as we all know... If your under 6ft , you might try another makers version.

 

[MasterEdi]

I'm starting my paint up on the first one, to see how it translates.... I'm about halfway there but I'm exhausted! Lol... So I'll post more pics and video of the end result when it's completed, but here's a preview....