Ironman faceplate motor kit

G

Gam3r

Member
Is there anyone out there who's selling a complete kit to make a motorized faceplate? I found a guy on Ebay, but he wanted €110 plus shipping for it, and I thought that was a bit too much..so I was wondering I anyone in here were selling? :) And I'm thinking about just the faceplate, not the chin part ;)
 
You need a servo, mount, hinges, and a custom programmed controller board. Yes, you can probably do all that yourself for less than that amount, but not by much.
 
Contact XRobots on this forum or through his website.He's also on youtube and knows the right companies (at least for the UK).
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

IM Nation
The making of Ironman mark 1 made.of eva rubber foam
Replies
2
Views
682
IM Nation
IM Nation
renaissance_man
Build Infinity Gauntlet - Fanhome Subscription kit
Replies
3
Views
1,052
Hecubus114
Hecubus114
alteredfabrics
LED helmet eye kits questions
Replies
0
Views
552
alteredfabrics
alteredfabrics
lmgill
Aluminum Ironman helmet
Replies
1
Views
1,092
Murdoch
Murdoch
M
Motorized doc ock costume
Replies
15
Views
1,885
Hylanos
Hylanos
Back
Top