Forbidden Planet Pub Table


Well-Known Member
I just completed a custom pub table...The base was an auction find..only $6! I made my own top from oak and gave it a routed edge. I put an additional plywood support underneath that connects to the top and to the base. I then projected the movie poster on the table (I put it on it's side on a bench to project and paint) and did some painting. It still needs the top coats that will protect it from all the beer that is bound to fall on it, but it's coming along!


better image...
Last edited:
Cool, you could put a round piece of tempered glass for a little more protection after you clear coat it. Base is neat.
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.