Foam and fiberglass

BGL

Member
Ok im really sorry as im probablly off topic or at the wrong place to post my question.

Ive been building part of my new project sculping insulation ( pink foam and foam card ) ive read a lot on internet about what to use or not but im just wondering if someone have experience on this.
Option
1 poly fiberglass = melt the foam, not a good idea.
2 epoxy fiberglass = ive read it is good to go is this right ?
3 coating the foam with something then fiberglass it ?
4 expensive stuff ...

Thank you very much and again sorry if im posting this at a wrong place.
 
I think gorilla glue is the type of glue you need to use to coat the foam first, then you can coat it with fibreglass/bondo.
 
I think gorilla glue is the type of glue you need to use to coat the foam first, then you can coat it with fibreglass/bondo.

Kind of water it down paint over it make sense how many layer should i try and after polyester of epoxy resins can be the best ? Soo many question lol :lol
 
the best idea ive seen with the pink insulation foam is covering it with aluminum tape. you can fibreglass over that, and it will come off easily.
this is the stuff:
Aluminum_Foil_Tape.jpg


it may work with regular duct tape too, but im not sure of that
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top