falcon belly APG


New Member
I need some tech. ideas ..I drilled and filed out the hole for the gun on the belly of the Falcon(AMT).after I have all the info on where it was...now I would like to make the gun go up and down and the door has to open and close..I was thinking mini motors , but I am at a blank...any help? thanks..
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.