EPS Foam to Automotive Finish

Thread starter PainterDave
Start date Aug 30, 2019

PainterDave

New Member

Aug 30, 2019

Hello ! Some amazing talent on this forum. i'm currently looking for some info on what people are coating EPS foam with.

Right now im coating with a Poly-coat 750 flex "Poly-urea" using a Hydraulic machine at a 1:1 ratio, i am finding it difficult to find stuff to stick to this coating.
dual mix epoxies (automotive style) work very well buy at 40 bucks for 7oz is a little expensive. even if you think it may not be relevant to the finish im after id like to hear it thank you.

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.